This project looks at the potential of blending ethanol with natural gasoline to produce Flex-Fuels (ASTM D5798-13a) and high-octane, mid-level ethanol blends. Eight natural gasoline samples were collected from pipeline companies or ethanol producers around the United States.
The objective of this work was to measure knock resistance metrics for ethanol-hydrocarbon blends with a primary focus on development of methods to measure the heat of vaporization (HOV). Blends of ethanol at 10 to 50 volume percent were prepared with three gasoline blendstocks and a natural gasoline.
High-octane fuels (HOFs) such as mid-level ethanol blends can be leveraged to design vehicles with increased engine efficiency, but producing these fuels at refineries may be subject to energy efficiency penalties. It has been questioned whether, on a well-to-wheels (WTW) basis, the use of HOFs in the vehicles designed for HOF has net greenhouse gas (GHG) emission benefits.
This study focuses on the simulation of a complete process for producing butanol via
acetone, butanol, and ethanol corn fermentation.
We assessed the life-cycle energy and greenhouse gas (GHG) emission impacts of the following three soybean-derived fuels by expanding, updating, and using Argonne National Laboratory’s Greenhouse Gases, Regulated Emissions, and Energy Use in Transportation (GREET) model: (1) biodiesel produced from soy oil transesterification, (2) renewable diesel produced from hydrogenation of soy oil by using two processes (renewable diesel I and II), and (3) renewable gasoline produced from catalytic cracking of soy oil.
We assessed current water consumption during liquid fuel production, evaluating major steps of fuel lifecycle for five fuel pathways: bioethanol from corn, bioethanol from cellulosic feedstocks, gasoline from U.S. conventional crude obtained from onshore wells, gasoline from Saudi Arabian crude, and gasoline from Canadian oil sands.
In this paper, we assess what is known or anticipated about environmental and sustainability factors associated with next-generation biofuels relative to the primary conventional biofuels (i.e., corn grain-based ethanol and soybean-based diesel) in the United States during feedstock production and conversion processes. Factors considered include greenhouse (GHG) emissions, air pollutant emissions, soil health and quality, water use and water quality, wastewater and solid waste streams, and biodiversity and land-use changes.
A method is presented, which estimates the potential for power production from agriculture residues. A GIS decision support system (DSS) has been developed, which implements the method and provides the tools to identify the geographic distribution of the economically exploited biomass potential. The procedure introduces a four level analysis to determine the
theoretical, available, technological and economically exploitable potential. The DSS handles all possible restrictions and
The model is a vehicle fuel-cycle model for transportation systems. The model provides a set of outcomes that would involve feedstock production, biorefinery production, storage and consumer demand as the complete fuel-cycle. The data is internal to the model, but might be adaptive to different biofuels specifications. This model was developed by the Energy Systems Division at Argonne National Laboratory.